There isn't a switch to reset the light. You 'reset' the light by fixing the problem which is causing the light.
top right engine.. atop the transmission. Easily accessible with any pliers or wrench. A real do it yourselfer
To replace the brake light switch on a 1995 Geo Metro, first disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is typically mounted above the brake pedal arm. Remove the electrical connector from the switch, then unfasten the switch from its mounting bracket. Install the new switch by reversing the removal process, reconnect the electrical connector, and reattach the battery terminal.
To remove the light switch in a Geo Metro, first disconnect the negative battery cable to ensure safety. Then, gently pry off the switch cover using a flathead screwdriver. Once exposed, carefully disconnect the wiring harness from the back of the switch and unscrew any mounting screws if applicable. Finally, pull the switch out of the dashboard or panel.
The engine computer through the brake light switch.The engine computer through the brake light switch.
"Check Engine" light comes on when you turn ignition switch on and should go off when engine cranks.
The engine of a 1996 Geo Metro weighs approximately 150 to 200 pounds, depending on the specific engine type and configuration. The Metro typically came with a 1.0L or 1.3L four-cylinder engine. This weight is relatively light compared to many other engines, reflecting the Metro's design as an economical and fuel-efficient vehicle.
I would start with replacing the head light switch
No reset switch on a Dodge Ram.
The 1998 Nissan brake light switch is located below the dashboard, on the drivers side of the engine compartment. The brake light switch simply plugs in and out.
Try resetting the fuel cut off switch and see if the engine will start
The stop engine light might not come on on your N14 Cummins when the switch is off.
How do I switch off engine light off my 2003 opel corsa bakkie 1.4