switch is located inside the hood in corner right side fender screw in firewall is vaccum style switch
ok it should have lock in hubs so pull your 4x4 switch onto 4x4 high and get out and turn your hubs on both sides on your front wheels
from 89 through 1996 the rims have the same bolt circle and from 1997-2003 and 2004-2011. However, if the tires are larger than stock on the 4x4 you will probly have clearance issues on the 2x4.
2000 ranger 4x4 i replaced the gem and selector switch no power to transfer case motor
Switch, circuit, shift motor
The 4x4 shift motor on your truck is likely bad. It is located on the back side of the transfer case. Any time the lights for your 4x4 don't come on, this is the most likely culprit. The dash mounted switch just tells the motor which of 3 positions it should be in (4x4 Auto, 4x4 High, 4x4 Low). There are contacts inside the motor which tell it which posotion it is in and whnere to stop for the different modes. If these contacts become dirty, it won't work properly. code P0735 is: Gear 5 Incorrect ratio ... This is a transmission code.... which is not affected by the 4x4...
Its on the upper right hand side of the motor right above the coil
where is the fuel pressure regulator located on my 2003 ford 5.4 f150 4x4 ???
My Explorer did that and I had to take the dash panel out where you will find a black or green box right beside where the radio goes, you will have to replace it.
4X4=12
It is the plug for the 4x4 switch on electronic shift 4x4 F-150's. Ford just uses the same wiring harness for all the trucks.
Who cares
Howdy, Pushbutton 4x4 use a electric motor to move the shifter fork in the transfer case to 4x4 and then into 4wd Lo range. This unit has a electric motor, a small gear box and a contact switch inside this little unit that is mounted to the transfer case. The contact switch is very light duty, and will either wear out or corrode from road salts, water, etc. I have had many apart and the only way to fix this problem is to change the complete unit (Around $175.00) as they are not repairable. I have had a few apart to see exactly the workings. What is happening is when your switch in in one position on the dash, the switch will make a contact in the contact switch on the motor telling the computer to turn on a light, which in turn makes to electric motor engage the transfer case into another position that you didn't call for, like 4x4 or 4x4 LO. Replace this motor assy or it will tear out your transfer case. E-mail with more questions. cowboysairranch@wildblue.net