Just disconnect the plug at the compressor. The A/C compressor will no longer function.
The ac compressorThe ac compressor
yes there is a seal on the front of compressor that can go bad and leak freon.
yes you can, just go buy an ac bypass pulley, pull your compressor, and put pulley in its place
Look for how it is attached and remove the needed fastners or components. No majic unfortunately.
The AC compressor could be locking up. Don't run the AC until you have it checked out. When the AC compressor starts to go bad it can send metal junk into the AC system causing trouble and $.
You will need more than the AC Compressor for this. The refrigerant is different. You will need all the components to go with the newer version Compressor.
First make sure you have freon in your AC system, at least 85#'s of standing gauge pressure. If you do then unplug the wire harness on the AC compressor and put the test leads of a volt meter, set to DC volts, to the 2 wires in the plud. You should read 12vdc. If you read the 12vdc at the plud and when you plug it back to the compressor nothing happins your clutch is bad. Note that if the freon charge is gone or very low there is a pressure switch that will keep the 12vdc from making it to the plug.
the Clutch is not fully disengaged. compressor might need to be replaced. I would bring it to the shop. Look at the Compressor and if u notice shavings then it has done its duty. If you do not want the AC anymore and want a cheap fix. Just go to a AC shop and get them to remove the clutch. the Clutch is not fully disengaged. compressor might need to be replaced. I would bring it to the shop. Look at the Compressor and if u notice shavings then it has done its duty. If you do not want the AC anymore and want a cheap fix. Just go to a AC shop and get them to remove the clutch.
up to the level recommended by the manufacturer or up to the fill plug hole
toward the bottom of the radiator on the right (passenger) side. It is located in front of the AC compressor
Bad clutch on compressor, unplug the wires from the AC compressor, replace fuse if doesnt blow fuse its in compressor, if blows then gounded wire