I think under the hood covered with shroud on the firewall.
Where can I locate the "Lamp Control Module" on a 1994 Buick Park Avenue
It is located under the dash near the blower motor.
The 2000 Chevrolet Corvette blower motor control module can be found behind the passenger side dashboard. You will need to remove the dashboard in order to access the module.
where is the engine controle module located in a 1995 buick lesabre
It is located under the hood on the passenger side, it screws into the evaporator case.
On the firewall to the right (when facing the firewall) of the blower motor.
I have an 89 Delta 88 and if you have Electronic Climate Control there is a control module located just right(passenger side) of center at the firewall. It is in the same location as the blower fan resister assembly on a car with standard a/c controls.
Something called a blower control module takes the place and is found in the hole where you would find a blower resistor, so there isn't a blower resistor in that vehicle. As far as the blower control module is concerned, the module is serviced as a unit. No part can be fixed or replaced. This is not to be confused with the control head in the dash. The blower control module is held into the heater box with two 8mm screws outside the firewall under the hood, where you would normally find the blower resistor pack.
i think what you are refering to is a blower staying on all the time, if so the blower motor has shorted the control module, you need to replace the blower motor and control module.
Behind glove-box, behind engine control module
, when you look the motor from the front it is located at your top left on the fire wall Close to the battery Mario
If your blower motor is either not turning itself off, or randomly turning itself on with the ignition off (and you have auto climate control), the problem is the blower control module. Located directly behind the blower motor, it takes information from the climate control, and is in charge of turning the blower on/off. To replace the blower control module, remove the splash shield under the passenger side dash (there's 3 plastic retainers hold it in place). The blower control module is located behind the blower motor, and is held in with 3 bolts. The 2 rearmost bolts (by the firewall) only need to be loosened, and the front one removed. The entire unit rotates down and can then be replaced.