On the firewall to the right (when facing the firewall) of the blower motor.
Blower motor speed resistors are generally located close to the blower motor.
The Mercury Cougar blower motor is located on the firewall in the engine compartment. The blower motor can be seen on the passenger side of the firewall.
Blown fuse, bad heater blower motor control switch, bad blower motor, or a bad blower motor resistor pack.
It is either your blower motor resistor pulling too much current, or the blower motor itself pulling too much current. The resistor is located underneath the dashboard behind a kick shield. The blower motor is in the enigine compartment, just behind the battery.
It is on the evaporator case and is held in with 2 screws.
It is located under the dash near the blower motor.
On the engine side of the firewall located approximately behind the position of the HVAC control module in the dash
If I'm not mistaken, it's behind the glove box passenger side.
under the blower motor housing. to the right
bad blower switch located behind blower control.
blower fan location on a 1979 lincoln
The blower switch is the knob you turn on the heater control in the dashboard. If you are talking about the blower motor resistor, it is located in the passenger's foot well area, mounted in the heater box.
on fire wall engine compartment
In a 1998 Lincoln Mark VIII : In the Power Distribution Box ( which is " live " ) located in the engine compartment ( # 29 is a 40 amp maxi fuse for the Blower Motor Relay )
It is located under the hood on the passenger side, it screws into the evaporator case.
If your blower motor is either not turning itself off, or randomly turning itself on with the ignition off (and you have auto climate control), the problem is the blower control module. Located directly behind the blower motor, it takes information from the climate control, and is in charge of turning the blower on/off. To replace the blower control module, remove the splash shield under the passenger side dash (there's 3 plastic retainers hold it in place). The blower control module is located behind the blower motor, and is held in with 3 bolts. The 2 rearmost bolts (by the firewall) only need to be loosened, and the front one removed. The entire unit rotates down and can then be replaced.
, when you look the motor from the front it is located at your top left on the fire wall Close to the battery Mario