It is an internal, non replaceable, part of the distributor.
Trouble code P1391 means: Intermittent loss of CMP or CKP
Call my phone .
CMP stands for Compare
Trouble code P0341 means: Camshaft Position (CMP) Sensor Performance
CMP = Certified Meeting Planner
Replacing the Sensor1. Disconnect the negative battery cable...just like on every other installation 2. Detach the CMP sensor connector next. 3. Remove the CMP sensor retaining bolt and remove the CMP sensor Now to install: 1. Clean the CMP sensor surface and ensure that the O-Ring is in place. 2. Position the CMP sensor into the engine and tighten the retaining bolt to 71-106 inch lbs. 3. Attach the CMP sensor connector 4.Connect the negative battery cable.
P0340 No Camshaft Sensor Signals At PCM - With Automatic TransmissionPossible Causes Setting Conditions * CMP sensor connector is damaged (check pins for damage, and for moisture) * CMP sensor signal circuit is open or shorted to ground * CMP sensor signal circuit is shorted to voltage * CMP sensor ground circuit is open * CMP sensor has failed * PCM has failed Engine cranking; system voltage over 10.0v, and the PCM detected CKP pulses without detecting any CMP sensor pulses for 5 seconds during 2.5 complete engine revolutions.This code sets in 1 Trip(s).This code will turn on the MIL (Malfunction Indicator Lamp)
Yes, you should fast for BMP or CMP
CKP=Crankshaft Position. CMP=Camshaft Position.
cmp-stands for "comprehensive metabolic panel" and 401.9 is a ICD9 code.
CMP typically stands for comprehensive metabolic panel.
Is a comet blood test the same as cmp