The sensor is located below the thermostat housing and is on the right side facing the vehicle. It is a little difficult to see and appears just as hasr to change due to limited space
It is on the inside of the valve stem.
The external air temperature sensor on a Chrysler PT Cruiser is located in the front of the motor. It is in the air intake tube that goes from the air cleaner to the motor.
It is just below the housing that the radiator cap goes on.
The computer uses the coolant temperature sensor to decide when to run the fans. It is below the radiator cap on the cylinder head.
There are two in the exhaust on the back of the engine.
the crank shaft sensor on 06 pt cruiser is located underneath the starter. It's a very tight spot, to remove you need a 8mm socket and you have to unplug the sensor once is out...Don't foget to disconet the battery.
the water pump on a 2003 PT cruiser is located between the inlet of the coolant supply hose and the outlet of the coolant supply hose It is inside the front of the engine, driven by the timing belt. The entire passenger side of the engine has to be disassembled.
It does not have a crank case sensor.It does not have a crank case sensor.
It is the three wire sensor on the driver side end of the cylinder head.
Behind the grille mounted on the condensor
Protects, no. The only temp sensor is the coolant temp sensor. The car will run until the engine is ruined if allowed to continue overheating.
7.4 quarts