Behind the grille mounted on the condensor
The 2003 GMC ambient air temperature sensor is located on the bottom of the drivers side mirror. If you look up at the bottom of the mirror you will see the sensor.
It does not have a crank case sensor.It does not have a crank case sensor.
on the dash to the left of the heater vent, peiece is held down by clamps just pop loose lift to access the sensor
It does not have a bank two.
In a 2003 GMC Envoy, the Ambient Air Temperature Sensor is typically located in the front of the vehicle, often near the grille or behind the front bumper. It may be mounted on the radiator support or within the air intake area. This sensor helps provide accurate temperature readings for the vehicle's climate control system. For specific access, consulting the vehicle's service manual may be helpful.
The ambient air temperature sensor on a 2003 Pontiac Vibe is typically located in the front of the vehicle, often near the front grille or behind the bumper. It may be mounted on the radiator support or near the air intake. For precise location, it's advisable to consult the vehicle's service manual or a repair guide.
where is the speed sensor located on 2003 Toyota matrix
where is temp sensor located for 2003 Hondaaccord lx
The Engine Coolant Temperature (ECT) sensor on a 2003 PT Cruiser is located near the thermostat housing on the engine. Specifically, it is typically found on the cylinder head, towards the front of the engine. To access it, you may need to remove any obstructions such as the engine cover or intake components. Always ensure the engine is cool before attempting to locate or replace the sensor.
It monitors the atmospheric (outside) temperature.
on the newer style dodges the temp sensor that you are looking for is held down by one of the bolts, i believe the top bolt, that holds the left(driver) headlight to the radiator support.
I have a 2003 Maxima SE. The ambient air temp sensor is yellow and it is located inside the grill under the hood latch - between the round bells for the horn. You will need a pair of plyers to hold the top of the yellow piece and a small flat screwdriver to push the little tab that hold the two parts of it together. Good Luck!