0
ecm is under right side of dash under glovebox. take down plastic shield under glovebox look all the way in the back behind heaterbox on firewall,one 10mm bolt holds it in .bolt also has ground wires attched to it. you may have to pull carpet back alittle to see bolt. unplug wires from ecm before you try to pull it down ,it's tight comming out but you can get it down. be sure you rehook up ground wires after your done. good luck!!!!!!!!!!!!!!!!!!!!!!!!!!!
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the ECM located on your 2000 Jimmy?
where is the ECM located on my 2000 Jimmy? where is the ECM located on my 2000 Jimmy?
Where is the ecm located in a 2000 Chevy Malibu ls?
Where is the ecm located in a 2000 Chevy Malibu
Where is the ECM location on 2006 F-250?
where is ecm located on 2000 f250 5.4l
Where are Vin numbers located on a 2000 Mitsubishi Galant?
The Vin numbers on a 2000 Mitsubishi Galant are located in two separate places. One is located on the drivers side door and the other is located on the top of the dash under the windshield.
Where is the ecm pcm located on a 2000 Daewoo lanos?
The ecm is located under the front passenger seat on my wife's 2000 Daewoo Lanos. This is an American version of the car.
Where is the ecm pcm located on a 2000 daewoo nubira?
In 2000 Daewoo Nubira the ECM is located on the front passenger side wall by the front passenger right foot.
Where is the ecm located on a 2000 Buick?
under the air box
Where is the ecm on a 2000 s-10 zr2?
The ECM on a 2000 S10 ZR2 is located under the hood. It is on the top of the passenger side inner fender.
Where is the ECM on your 2000 Mazda Protege?
The ECM on the 2000 Mazda Protege is located on the backside of the engine. It is half way up above the drive shaft.
Where is the ECM located on a 2000 Chevrolet grand prik gtp?
there is no such thing.
Where is ecm for 2000 Monte Carlo ss located?
In the airbox, no joke.
Where is the ECM located on a 2000 VW Jetta?
ECM is located on drivers side, below the base of the windshield underneath the plenum. You have to remove plenum panel for access.
