I Have a 1991 3000gt Sl and the ECU Is located Behind the radio and can accessed by removing the side carpet panals for your gear shifter.
To reset the ECU on a 1993 Mitsubishi 3000GT SL, first, disconnect the negative battery terminal and wait for about 10-15 minutes to allow any residual power to dissipate. Then, reconnect the negative terminal. This process will clear any stored trouble codes and reset the ECU to its default settings. If needed, you can also use an OBD-I scanner to clear codes more effectively.
YES.
location of the ecu on 1993 Lexus LS400
The Engine Control Unit (ECU) on a 1993 Cadillac STS is typically located under the dashboard on the driver's side, behind the glove compartment. You may need to remove the glove box for easier access. The ECU is housed in a metal case and is connected to various wiring harnesses. Always ensure the vehicle is turned off and disconnected from power before attempting to access or service the ECU.
3000gt Mitsubishi 1992 is jumping out of reverse
I have a 1993 Mitsubishi 3000gt and the TCU is located under the console / dash. It is mounted by a metal bracket to the floor pan. You will need to remove the side carpet panels and the entire front console to access the TCU.
To reset the ECU on a 1995 Mitsubishi 3000GT Base, disconnect the negative battery terminal and leave it off for about 15-30 minutes. This allows the ECU to clear its memory and reset itself. After the waiting period, reconnect the negative terminal, and start the car to allow the ECU to recalibrate. It's also a good idea to drive the car for a short distance to help it adapt to normal driving conditions.
The ECU on a 1993 Cadillac Deville is behind the glove box. To remove the ECU, remove the bolt and pull down the plate.
I had same problem, but this can be caused by a few different things. its either the PTU, the coil pack or the ECU, more often than not its the ECU!
The ECU (Engine Control Unit) on a 1993 Acura Integra is located under the dashboard on the driver's side. It is typically mounted on the metal brace or near the steering column. To access it, you may need to remove some panels or cover to reach the unit.
On a 1993 Ford Ranger, the Engine Control Unit (ECU) is typically located under the dashboard, to the left of the steering column. You may need to remove some trim or panels to access it. It's often mounted on the firewall or near the instrument panel. Make sure to disconnect the battery before attempting to access or work on the ECU.
electronic control unit (ecu) that would be the computer for your engine