well looking at the motor from the front of the car it is on top towards the back. it is the round shiny disc with a black plug on the top.
location and replacement of pcv valve and egr valve on 2005 Ford Taurus se
Were is the egr on a 1992 mazda protege
There is no EGR valve on the '92
1990 -1993 injected Festivas do not have a EGR valve
do you mean the EGR valve? The Exhaust Recirculation Valve? EGR
If you can find the EGR valve you'll see a wire connector/plug on top of it...that's where it is. It can be replaced by unplugging the wire connector and removing the small screws that fasten it to the EGR valve It is usually called an EVP (EGR Valve Position) sensor.
its on the back of the valve cover.
This issue is typically caused by a broken or jammed EGR (Exhaust Gas Recirculation Valve). To remedy the problem, you must remove the old EGR valve and replace it. Attached is an Article from AutoZone on how to determine if it is the EGR valve and how to replace the EGR on a Generation 3 (1996-1999) Ford Taurus, It will also determine if your problem lays in other EGR components.
I HAVE NOTICED THAT FROM 87-92 MANY AUTO MAKERS DID NOT USE AN EGR VALVE...EXAMPLE 88FORD TAURUS,92 TOYOTA COROLLA
I have a 1992 Dodge Spirit and it doesnt have an Egr Valve, but that's for the basic spirit, if you have an es, or anything, it will be located on the Intake Manifold. Its not hard to spot cause they usually say EGR across the top of it.
AnswerThe 3800 (RPO: L27) was not equipped with an EGR Valve for the model year 1992 only. The 3800 (RPO:L67) does have an EGR valve.The valve should be located on the driver's side on top of the manifold.A bad EGR valve can keep your car from starting and running properly.
The egr valve is located on top of the engine. It is close to the firewall, mounted close to the center from side to side.