"EGR" valve?
3.5L high output
The high oil pressure relief valve is located in the oil pump
The high pressure charging valve is located either on the high pressure line or the muffler, and the low pressure charging valve is located either on the accumulator or low pressure line.....
It is located under the housing where the lower radiator hose hooks to the engine.
The short runner valve is the square item sticking out of the end of the intake manifold. The code refers to either a failed actuator/position sensor or a wiring problem from the pcm to sensor.
The low pressure valve for the refrigerant is different depending on if you have rear AC or not. With Rear A/C: The High pressure valve is located just to the left of the radiator cap. The Low pressure valve is located on the dryer (the large silver can) right beside the radiator cap. Without Rear A/C: The high pressure valve is located just to the left of the radiator cap. The low pressure valve is located in the line between the compressor and the dryer, against the firewall, above the motor (it is hard to see and access). ***WARNING*** Overcharging your system could result in an explosion.
need to replace the fast idle valve. they are only located a the dealership.... good luck need to replace the fast idle valve. they are only located a the dealership.... good luck
the heater control valve or DCCV (dual climate control valve) is located next to the radiator on the passanger side just below the high pressure side service connector
Yes, they are all high brass and considered magnum loads
The expansion valve is located between the evaporator and the high and low pressure line connections. It is in the firewall behind the engine. Follow the hoses to the passenger compartment and they will terminate on the expansion valve.
About $250.
High Output(more power) High Output(more power)