THE MAF sensor is located immediately next to the air filter box; it will be mounted right to the side/top of your air intake "hose" and have a wiring harness connected to it.
Toi remove and clean, disconnect the wiring harness, remove/unbolt the MAF sensor, and clean gently with CRC "MAF CLEANER" spray (gently spraying from several inches away). Allow to dry, and repeat the sprayout. Allow to dry, remount and reconnect the wiring harness.
Remember with I30's as with most ECU (electronic control units) it will take 50 or 60 miles of driving to update the ECU memory with new data, unless you have a diagnostics unit to reset the ecu. (Disconnecting the battery may or may not work depending upon the condition of the ecu battery backup)
Where is the knock sensor in a 1999 Infinity I30?
a swivel socket
location of crankshaft sensor on 1997 Infinity I30 is it on the engine or in the gas tank plz show a pic
1998 i30 has timing chain. just confirmed from my dealer.
The 1998 Infiniti I30 & Nissan Maxima doesn't have a timing belt. It uses a timing chain.
How can I chang the speed sensor in a infenti I30 model 2000?
The knock sensor on a 99 Infinity I30 is located on top of the engine near the intake manifold. It monitors the engine's combustion and helps it adjust when the ignition time becomes off
were is the egr valve located on a 1998 infiniti i30
if your code is po500 check the wires between speed sensor and cluster .mostlikely your problem is in the cluster
The knock sensor for a Infiniti i30 is located or attached to the cylinder block. It is usually located at the top of the block in the center towards the front of the block.
Should be in a housing located at the engine end of the upper radiator hose
How do you change the spark plugs (or tune up) in a 2001 Infinity I30