answersLogoWhite

0

On the 2.5L it is located on the exhaust manifold directly under the intake manifold on the drivers side, you can locate it by tracing the electrical connection to the ehaust manifold as there is only one connection, the 02 sensor.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Egr valve in 1986 jeep comanche?

The 1986 Jeep Comanche EGR valve is located on the outside of the air cleaner housing. The valve can be found on the back of the housing.


Where is the fuel pump located on a 1986 Jeep Comanche?

inside gas tank.


Where is the fuel flter located on a 1986 Jeep Comanche?

It is under the back of the cab on the inside of the unibody rail.


Is the fuel pump located in the tank on a 1986 Jeep Comanche 2.5 motor?

No it is not i think it is inside or beside the oil pan


How many years did they make jeep Comanche?

from 1986 to 1992.


WHere are the fuse and relay for the fuel pump on a 1986 Jeep Comanche?

The fuse and relay for the fuel pump are located in the engine. The pump itself is located in the gas tank.


Where is the oil sensor lacated in Jeep Comanche 86?

on a 2.5L AMC four it's located above the passenger side engine mount.


Would an engine from a 1988 jeep Comanche go into a 1991 Jeep Cherokee?

no. 1986 to 1990 sorry


Where is the horn on an 1987 Jeep Comanche?

It should be right behind the grill. It is on a 1986.


Where is the IAT sensor located in a Jeep Liberty?

Where is the speedometer sensor located in a Jeep Liberty 2002?


Where is crank position sensor on 1989 Jeep comanche?

On a 1989 Jeep Comanche, the crank position sensor is typically located on the engine block, near the flywheel or the rear of the engine. It's often mounted to the bell housing of the transmission, where it can read the position of the crankshaft. If you're having trouble locating it, refer to the vehicle's service manual for specific diagrams and instructions.


When was Jeep Comanche created?

Jeep Comanche was created in 1985.