On a 1988 Honda Prelude Si, the oxygen (O2) sensor is typically located in the exhaust manifold or just after it in the exhaust pipe. It is positioned upstream of the catalytic converter, where it can effectively measure the oxygen content in the exhaust gases. To access it, you may need to lift the vehicle and possibly remove some components for better visibility. Always consult the vehicle's service manual for specific instructions and location details.
The O2 sensor on a Honda Prelude is found on the exhaust pipes of the vehicle. They are located near the catalytic converter which is place on the underside of the chassis.
Yes. It's located in front of the catalytic convertor.
there should be a couple of them screwed into the exhaust system.
On the Prelude there are 2 O2 Sensors. They are on the exhaust manifold on the front of the engine. You will need to remove part of the plastic air intake in order to reach them.
the exhaust, where every o2 sensor is
The O2 sensor on a 1988 F250 is not near the engine. Go to the exhaust manifold and down the length. It is near the catalytic converter.
on the passenger side exhaust pipe. Just under the passenger door location.
you possibly blew a fuse. it may not be related to you O2 sensor
The O2 sensor can be found on the outside of the air cleaner housing. The O2 sensor will be attached to the back of the air cleaner housing.
where is the 02 censor located
Where's it located? O2 sensor is in your exhaust so if uts not in the exhaust thrn no
The oxygen sensor on a 1988 Astrovan is located in the exhaust system. There are two oxygen sensors, one on the driver's side and one on the passenger side of the exhaust.