The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.
where is 2005 Nissan speed sensor located
where is it located
where is the knock located on 2001 nissan altima 2.4
The crankshaft sensor on the 1998 NISSAN ALTIMA is located next to the radiator side of the harmonic balancer
where is speed sensor on 2000 nissan altima What are the procedures on installing a speed sensor on 2000 nissan altima
In a Nissan Altima.
its located in the trottle body
where is the camshaft sensor on a 2005 Nissan altima
It's part of the throttle body, entire unit must be replaced.
I HAVE A PO725 CODE IN MY 2005 ALTIMA, WHERE IS THE ENGINE SPEED SENSOR AT,THANKS 2.5
I don't believe that the altima had a crankshaft position sensor until 1995.
The 1995 Nissan: temperature sensor is located on the front of the engine. The coolant temperature sensor will be near the thermostat housing.
It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.
There is none; it's the distributor.
located at the bottom of radiator
Located in the distibutor!!
can you forward me a picture of the speed sensor to a 2006 nissan altima?
There is no MAP (Manifold Absolute Pressure) sensor in a 2002 or later altima. This altima uses a MAF (Mass Airflow Sensor). It is in the intake and has a clip with 5 prongs.
The coolant temperature sensor of a 1998 Nissan Altima is located beside the upper radiator hose. It constantly updates the vehicle's computer about the engine's temperature.
If just the knock sensor need to be replaced. I would say no more than $150.00
How can you tell if a crank sensor has gone bad on a 1994 Nissan altima
The coolant temperature sensor, on your 1999 Nissan, is located a few inches above the water pump. The sensor will have two wires going to it.
It's in the distributor. The whole distributor gets replaced when you nneed a new one.