0
On a Renault Modus 1.5 dCi, the O2 sensor is typically located in the exhaust system. There are generally two O2 sensors: one before the catalytic converter (upstream) and another after it (downstream). You can find the upstream sensor near the engine, connected to the exhaust manifold, while the downstream sensor is located further along the exhaust pipe, near the catalytic converter. To access either sensor, you may need to lift the vehicle for better visibility and reach.
What else can I help you with?
Coolant sensor in a Renault megane?
Yes there is a coolant sensor in the Renault megane.
Do you need upstream or downstream oxygen sensor?
Depends on what the problem is or what code was set.
Wear is TDC sensor on Renault magane?
renault magene coupe..2ltr sensor 8200156362
How do you replace the TDC sensor on a Renault scenic?
How do you change the TDC sensor on the Renault Scenic RX4
Does a cracked manifold in a Renault Megane affect emissions?
If you are referring to the exhaust manifold then it should not affect emissions as the o2 sensor is after the exhaust blow it will adjust emmissions accordingly
Where is the o2 sensor in a 99 firebird located?
the exhaust, where every o2 sensor is
Where is the O2 Sensor Located on a CRX?
The O2 sensor can be found on the outside of the air cleaner housing. The O2 sensor will be attached to the back of the air cleaner housing.
99 cavalier o2 sensor?
The upstream O2 sensor is mounted in the ehxaust manifold The downstream O2 sensor is mounted in the exhaust pipe after the catalytic converter
Where is o2 sensor 1998 Sunfire?
The upstream O2 sensor is mounted in the ehxaust manifold The downstream O2 sensor is mounted in the exhaust pipe after the catalytic converter
Where is the O2 sensor on 1993 Toyota T100?
Where is the O2 sensor on 1993 Toyota Mr2
Where is the fuse for the O2 sensor on a peugeot 206 2004 plate?
There is no fuse for the O2 sensor.
How do you replace the Rear o2 sensor on 2000 gmc jimmy 4x4?
Remove the vacuum hose from the O2 sensor. Remove the wiring harness. Remove the O2 sensor retaining screws. Reverse the process to install the new O2 sensor.
