On the passenger side of the engine block, between the oil pan and the oil filter.
The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.
very carefully
were is the oil pressure sensor located
Are you referring to the (oil pressure sensor) or the (oil pressure regulator)?
is this a bmw? if so, it may be a defective thermal oil level or oil temperature sensor. the sensor may be internally defective or shorted out. the brief flashing is the signal that the sensor need to be checked. if it is not a bmw, your oil level may just be low. if it is correct, the oil pressure switch may be defective.
Affiliated with the oil pressure sensor
The oil pressure sensor on a 2004 BMW 325i is located on the bottom, right side of the engine. It is screwed into the block and has an output wire which sends information to the computer.
normally the oil pressure switch is on the main block if you have a pressure guage or oil pressure light on the car if you disconnect the right switch the gauge will drop or the light will go out then you know that's the switch to change.
How to change oil pressure sensor on 3.4 sfi
its on the oil filter case towards the rear of it .
Engine Oil Pressure Sensor and/or Switch Replacement == J 35749 Oil Pressure Switch Socket # # Remove the air cleaner outlet resonator. # Disconnect the oil pressure electrical connector. # Remove the engine oil pressure sensor (1) usingJ 35749 . # # Install the engine oil pressure sensor (1) using J 35749 . # Connect the oil pressure electrical connector. # Install the air cleaner outlet resonator.
High oil pressure is good....