the PCV valve is located on the valve cover of a 1991 Regal Custom. It is plugged in and can be easily changed.
The PCV valve on a 1994 Regal Custom should be located on top of the valve cover. It is a plug in type and is easily changed.
Freon valve on my 1989 Buick Regal Custom 3.1 V-6 located on driver side under the area of battery tray. Hope this helps!
The PCV valve for a 1999 Regal 3.8 is located on the top of the valve cover. The valve pulls out to replace it.
On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.
Where is the heater control valve on a 1994 Buick Regal
Front (belt side), top of motor. it is covered by a plate with 3 bolts holding it on. Careful, it is spring loaded.
The PCV valve for a 2001 Buick LeSabre is located in the top of one of the valve covers. It is a plug in unit and is easily changed.
the pcv should be near the front valve cover
At the top of the engine near the firewall and directly behind the carburetor.
How to fix heater in Buick there is cool air ,fan is work .but no warm air
located on vale cover
it is on the throttle body. usually held in by two screws.
It is bolted to the side of the cylinder head closest to passenger compartment on driver's side.
The PCV valve on a 1995 Buick Park Avenue is located on the top of the valve cover. Twist the valve and pull to remove and replace it.
where is the pcv valve located on a 2001 buick lesabre
located around intake area...
mine does not have one
on the valve body
On my 1998 Buick the valve was located near the battery. Mine was damaged during a hurried winter battery change.
The PVC valve for a 1991 Skylark should be located on the top of the valve cover. It is a plug in type, twist and pull to remove.
Hey Andre==You don[t say which side but just get everything out of the way, remove the screws and take the valve cover off.
If you have a 3.3L the PVC valve is located under the alternator.
Remove the float from the Regal. inspect the float for leaks, then check the spring and needle valve as it could be stuck. If all parts are ok then the parts need cleaning as they are sticking.
The PCV valve plugs into the rocker arms cover or intake manifold.
If you have a Supercharger...It's inside. You can access it from the top. Two bolts (10mm) and nothing coming out of the top. It's completely concealed. Be carefull there's a spring inside and you will have to get a new gasket. GRRRRR.