Oldsmobile Alero

Where is the PCV valve located on a 1999 Oldsmobile Alero?

232425

Top Answer
User Avatar
Wiki User
2006-03-20 05:51:58
2006-03-20 05:51:58

on the 3.4L V6 it is located on the front valve cover, just to the right of the oil filler cap. there is a hose with a 90 degree boot on it. remove that and pull out the PCV valve.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you replace head lights on my 1999 oldsmobile alero?

User Avatar

Show me a diagram of the starter location on a 1999 Oldsmobile Alero

User Avatar

The Oldsmobile AleroThe vehicle that replaced the Achieva was Oldsmobile Alero (produced from 1999-2004).

User Avatar

In the 2000 Alero, it is fuse 34 in the engine fuse box, which is located near the battery. You can check the same fuse for the 1999 Alero and see if that is it.

User Avatar

Look on the front valve cover and it is to the right of the oil fill cap. There will be a black hose going to it that makes a 90 degree angle. Pull that off and then pull the PCV out.

User Avatar

what does the engine light on the 1999 olds alero mean

User Avatar

Totally depends on engine. If you dont see them right off, your are most likely located under the big valve cover similar to the hemi engines of Chrysler.

User Avatar

It is located on the passenger side on the bottom of the engine near the firewall.

User Avatar

On a 1999 Oldsmobile Alero, the knock sensor is located on the engine block. It may be bolted to the intake manifold, or to either side of the block.

User Avatar

Their is no 1993 olds alero the first year is the 1999 sorry.

User Avatar

No, a wheel bearing should not set off a low tire pressure light in a 1999 Oldsmobile Alero.

User Avatar

How do you set the clock in a 1999 Oldsmobile Alero? I did not receive a book with the car and I really would like to have the right time in my car.

User Avatar

under the rear of the car just behind and above the gas tank

User Avatar

The 1999 Oldsmobile Alero OBD 2 port is on lower left edge of dash; between storage bin and hood release

User Avatar

The coolant air bleed valve is located on the top of the thermostat bypass pipe/heater pipe assembly. Close the valve once a continuous stream of coolant is expelled from the valve.

User Avatar

The Oldsmobile Alero was produced between 1999 and 2004. The compact car was manufactured in Lansing, Michigan, and was Oldsmobile's last vehicle sold under the brand.

User Avatar

The holes is called the bypass holes I had the same thing happened to my alero

User Avatar

i have a 2001 olds alero 3.4 V6 and the thermostat on mine is underneath the throttle body...this may vary from your '99 vehicle, and it also may vary depending on your engine size

User Avatar

Drivers side, mounted on the firewall, behind the master cylinder. Coming from that booster is a large vacuum line.

User Avatar

Usually located at the passenger's side firewall Some are accessed under the hood others behind glove box area

User Avatar

where is the camshaft position sensor located on a 1999 Oldsmobile intrigue


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.