answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2014-07-03 18:50:50
2014-07-03 18:50:50

The PCV valve on a 2002 Chevy Suburban 6.0 liter engine is located in the engine. You cannot miss the valve.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


It is pushed in the top rear drivers side valve cover and has a vacuum hose hooked to it.


The 1999 Chevrolet Suburban 1500 5.7 liter V-8 air check valve can be found on the firewall in the engine compartment. The air check valve will be on the drivers side of the firewall.


Yes the 2.2 liter 2001 Chevy Cavalier does have an interference engine. This means the valve and pistons share the same space in the engine.


where is the heater control valve on a 1994 2500 suburban


All GEN III GM egines (5.3L,6.0L,8.1L and LS1)have an internal PCV You do NOT change them....... well like most truck they are locted on top or back beside the maifold it will have a hose that goes to it one the passinger side at the top of the motor I am not positive, but I do not think it has a PCV valve. The Positive Crankcase Ventilation (PCV) valve on the 2002 Chevy Suburban with the 5.3 liter engine is located at the rear of the left valve cover-pull it out and check for vacuum with you finger.


The 1999 Chevy Geo Metro 1.0 liter engine PCV valve can be found on top of the engine. The PCV valve will be behind the air cleaner housing.


Where is front expansion valve for chevy suburban 1997


The cooling system bleed valve, on your General Motors 5.7 liter engine, is located on the bottom of the radiator. The bleed valve should be in the middle of the radiator bottom.


EGR VALVE IS LOCATED NEXT TO THE TOP RADIATOR HOSE AT THE ENGINE, IT CAN CAUSE ENGINE TO MISS, STALL AND SURGE.



The PCV valve is located in the rear valve cover next to the firewall. It can be reached and changed without rotating the engine forward although it is a bit of a struggle.


The pcv is located on either valve cover or the intake.


Its in the drivers side valve cover in back near the firewall


The brake dump valve on a 1996 Chevy Suburban is used for bleeding the brakes after new brake pads are installed. It is located on the master cylinder for each brake.


where is the pcv valve located on a 2001 chevy suburban It is stuck in a rubber hose and pushed into the top rear drivers side valve cover.



On top of the engine. Look for a plastic tube with the small green service cap then follow that line back to the engine. That line is connected to the purge valve. You will have to remove the black plastic engine cover to expose it.


The 1998 Dodge Grand Caravan 3.8 liter engine EGR valve can be found on the top of the engine. The EGR valve will be near the back of the engine.


The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.


There is no PCV valve on the 2.2 Liter engine.


if equipped it is on the driver side valve cover in the rear pointing straight up


2000 SEwhat year do you have, and do you have a 3.0 liter 12 valve engine, or a 3.0 liter 24 valve DOHC engine?12 valve


i have the 3.4 liter 2000 impala and its up against the top of the firewall towards the middle of the engine



The EGR valve on a 1994 Chevy 1500 is located on the top of the engine. If the valve becomes stopped, the engine could idle rough or stall.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.