try looking at the valve cover underneath the intake. that's where I found mine on my 89 V6.
How hard is it to change the rear main seal in my 1992 toyota pickup , with the 3.0 V6
Could be a worn out waterpump.
No, a 1992 Toyota pickup V6 transmission is not compatible with a 22R engine. The V6 transmission is designed for a different engine configuration and has different mounting points, bellhousing designs, and torque specifications compared to the 22R. If you're looking to swap components, it's essential to use a transmission specifically designed for the 22R engine.
Just to the left of the Oil filter towards the front of the engine.
Only the V6 has a belt.
yes it does if your water pump is leaking its most likely from there and you will have to get a new water pump installed.
Ah, the anti-knock sensor on your 1992 Toyota pickup with a V6 engine is located near the engine block. It's a small, important part that helps prevent engine knocking and keeps things running smoothly. Just take your time, be gentle, and you'll find it nestled in there, doing its job to keep your truck happy and healthy.
Approximately 4.5 quarts.
11.1
No , the 3.0 liter V6 engine in a 1994 Toyota pickup is NOT an interference engine ( according to the Gates website )
The spark plug gap for a 1994 v6 Toyota Pickup should be set at .032 inches. However spark plugs now come with the gap preset.
You will probably get a ticket for a very loud vehicle. No real benefit can be obtained by removing the muffler on a small 4 cylinder or V6.