Chevy Silverado
Ford Expedition
Ford Bronco
Ford Expedition XLT

Where is the PVC valve for a 1999 Chevy 1500?

345

Top Answer
User Avatar
Wiki User
Answered
2009-06-07 17:55:33
2009-06-07 17:55:33

drivers's side valve cover.midway back from front of truck...this fix is easy...pull it out from the valve cover ...attached to small diameter hose...and shake it to see if it rattles...they are cheap so replace it...and if it rattles....U know its the right part B.C.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


The PVC valve is located on the top of the engine. It is on the drivers side of the engine close to the back.


The PVC valve is in the valve cover.


were and how do you change a PVC valve on a Chevy avalance



The 1999 Chevy Malibu with the 2.4 engine does not use a PVC valve. Instead the system uses an oil/air separator that can clog up and cause the same symptoms.


It is the small plastic elbow that is on the top of the valve cover.


The PVC valve on a 1999 Maxima is located in the rear valve cover just behind the throttle body.


The PVC valve on a 1999 Maxima is located in the rear valve cover just behind the throttle body.



where is the pvc valve on a 1998 suaru forester?


you remove the dog house and it will be on the left valve cover


pcv valve is in the valve cover across from yhe intake plelum


Hey Minnie==Trace the fuel line from the tank toward the engine and you should find the filter about midway. The pcv is in the right valve cover. GoodluckJoe


where dose a pcv valve go no 1996 buick lasaber...


It is in a hose that goes in the top rear drivers side valve cover.


should be in the top of the valve cover on the passenger side and i believe you mean pcv valve right?


check on the valve cover it is normally inside it on the back part ont the passenger side


on top of the engine towards the drivers side of the auto


Standing in the front of the engine, It will be on the top of the right valve cover in the back.


The PVC valve plugs into the valve cover. Just unplug it, unplug the other end from a vacuum hose, then reassemble.


Check under intake is not a PVC is a air/oil separator


ware is the PVC valve 2002 deville


To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.


Colorados do no not have a PVC valve, they use a fixed orifice system. The PVC pipe is the main componet of the system. Checking pipe for leaks is the only service listed.


Pontiac PVC Valve is located on the Driver's side rear valve cover.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.