It is under the hood on the pass side of the engine in the valve cover.
To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.
It does not. I have a '93 Summit Wagon, that does not have it. I'm pretty sure it was in '94 they added a driver side airbag, and a passenger one in '95.
the PVC vlave is located in a hole on the top of the valve cover next to the oil fill cap.
It's next to the back of the front-right turn signal lamp. Look up from below.
It's on the front valve cover of the engine, it just pushes into a rubber grommet and there is a hose coming off of it.
im not sure on a 1990 but on my 93 civic ex 1.6 vtec the PVC valve is on the intake right under the fuel rail
fuel pump will be in the fuel tank, there will be an access panel hidden under the carpet so that you do not need to remove the tank from the vehicle. hope this helps
Has anyone looked ay the timing belt? Or done a compression test ? that's a pretty broad question.
On a 1993 Eagle Summit, the ignition coil is typically located near the engine, mounted on the intake manifold or on the firewall, depending on the specific engine configuration. It is usually a cylindrical component with electrical connectors attached. To access it, you may need to remove some engine covers or components for better visibility. Always refer to the vehicle's service manual for precise location and replacement instructions.
more the likely the distributor but check easy things 1st cap rotor ect... i know i own one too!ive replaced mine 2 times in 4 years!
its on the car
do you mean the PCV valve? the PCV valve is located in the intake manifold