connected to thermostat housing
1988 Chevy corsica fuel sending unit whai have a 1988 Chevy corsica i need to no on the fuel sending unit the bib line goes to what line and the two little lines go where please help
It should be screewed into the drivers side head between the first and second spark plugs. I have seen it on the other head at times.
rear drivers side engine block
At the rearmost section of the engine to the right of the distributor.
In a 1988 Chevy pickup the ECM is located behind the glovebox.
The oil sending unit is below the intake manifold, it is threaded into the block.
The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.
It is in the fuel tank
That year does not have 1.
If it's not located on the thermostat housing, where the top radiator hose attaches to the motor, then it's under the intake air chamber in the head.
Chevy did not use an Idle Air temperature sensor on that year.
The Oil Sending Unit on a 1988, 89, and 90 model Silverado is behind the driver side manifold. It is right above the oil filter. It is a canister that is bolted to a piece of tubing that leads to the motor.