answersLogoWhite

0

In a 1988 Chevy pickup the ECM is located behind the glovebox.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L


How do you set the timing on an 1988 Chevy Celebrity?

The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.


Where is the engine control module on a 1988 celebrity?

The engine control module is bolted to the inside of the firewall in front of the glove box drawer. If you remove the glove box drawer you will be able to see it.


Where is the ignition module on a 1988 Chevy Celebrity 2.5?

The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.


What happens when the module goes out on the 1988 Chevrolet celebrity?

What happens depends greatly on which module fails. If the engine control module (computer) fails it may cause the engine to run poorly or not at all. If the ignition module fails the engine won't start.


Where is the ignition switch module located on the 1988 Cherokee limited?

module locatedwhere is the module on a 9 Chevy blazer


Where is the control module located on a 1988 dodge ram 100 318?

On a 1988 Dodge Ram 100 with a 318 engine, the control module, commonly referred to as the engine control module (ECM), is typically located on the driver's side of the engine compartment. It is mounted on the firewall, near the master cylinder. For easier access, you may need to remove certain components or covers in the area. Always refer to a service manual for specific instructions related to your model.


Location of ignition module on 1988 Chevy silverado 2500 350 engine?

Follow the 2 pin connector from the top of the coil located on the driver side front of the distributor. It should lead to a 2 pin connector, as well as a 4 pin connector. This is the ignition control module.


What is the Ignition timing for 1988 Chevy 454 engine?

what is the ignition timing for a 1988 Chevy 454 engine


Where is the control module in an 1988 fifth ave?

Taking a guess, Your 1988 5th Ave has a 318ci motor with Lean-Burn Engine control. Chrysler put the control module in the rectangle box attached to the side of the air cleaner. All of the engine control module is inside that box to include the transistorized ignition system. Your distributor will have two pickup coils in it and not have a vacumn advance located on the side of it which will be another way of telling if you have the Lean-Burn system.


Where are the coil packs on a V6 Chevy Beretta?

On 1988-1993 V6 models, the coil packs and ignition control module are located at the lower front of the engine, facing the radiator. From 1994-1996, they were moved to the top rear of the engine, pointing slightly toward the cowl area.


Where is the beretta computer or module located?

I am trying to find the 1988 chevy beretta computer module and where is it located?

Trending Questions
If your 1991 Toyota Camry passenger side window does not open from the passenger side switch but opens from driver side switch are both switches on the same fuse? How do you set the clock on a Chrysler pacifica? Are there any reptiles in Denali park? Was a 400 ci engine available in a 1971 Pontiac Firebird formula with a column automatic shift? Why does your 1999 Chrysler cirrus oil light flicker or blink when im stopet and the car feels like its going to stall and it only does it when the car is warm? Where to put the transmission fluid in 1995 ford crown Victoria? How do the back seats fold down on a Mazda 3? Where is the distributor cap located for a 4.3 liter 2001 silverado? How do i close Fiesta bonnet? Is there anyway to be able to see or test a wiring harness to see if it needs replaced on a 1985 5.0 mustang? How do you replace your battery on your 2000 Pontiac Bonneville? What would cause a clunking sound in the front only when you hit a bump in the road..for a 2000 ford focus zx3? What would cause a 1996 Ford Ranger to idle high intermittently? What is the cause of 1999 suburban daytime run lights not working? What type of transmission fluid should you use in a 1985 jeep Cherokee 2.8l v6 automatic. will any ATF work or does it need a certain type? How many 1979 mustang cobras were made? Where is the fan relay located in the fuse box on a 2005 f-550? 1986 Jeep Grand Wagoneer fuse box? Why is your air in your truck not blowing air through the front vents? Which car is faster by a corvette or a SRT challenger?