0
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
Wiki User
∙ 11y ago
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you change the Ignition Control Module in a 1995 Blazer S-10?
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
How do you change the ignition control module on 1996 mercury cougar xr7?
there is no ignition control module on the 1996 model its all through the PCM
How do you change ignition control module 1995 Buick Riviera?
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
1994 silverado turns over but wont start what is the problem?
Have you checked for fuel and spark? Fuel pumps ad burnt ignition rotors are very commen on these vehicles
How do you change the ignition control module in a 1989 Chevy Celebrity?
Which engine does your car have?
Where is the location of the ignition control module on a Ford Focus?
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
Where is ignition module 1993 Chevy silverado 1500?
inside the distributor
Where is the ignition control module on a 1992 Crown Vic?
Where is the ignition control module located in my 1992 Crown Victoria
Where is the ignition control module in a 1997 mercury villager?
The ignition control module sit directly below the distributor.
Where is the ignition module on a 88 tracer?
ignition control module is under the distributor cap
Were is the ignition control module on a 2001 Mercury Sable 3.0 dohc?
Where is ignition control module on a 2001 mercury sable
Where is the ignition and distributor located on a 1990 Chevy Celebrity?
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
