0
What else can I help you with?
How do you change the hood release cable on 92 Plymouth Voyager?
Junk vehicle.
How to get the spare tire off of a 1992 Plymouth voyager when the cable will not crank down?
I THINK IT`S TIME TO CUT THE CABLE .I SURE YOU HAVE NOTHING BUT RUST.
How do you change a accelerator cable on a 95 lumina van?
The accelerator cable is connected with a swivel nut on each end of the cable. Loosen the swivel nut, by turning it to the left. The accelerator cable will come off. Reverse the process to install the new accelerator cable.
Where is the accelerator cable for 96 thunderbird lx your cable snapped do you know why it would do this?
the cable is located at the top of the engine behind the throtle body if it is a 4.6L V8.
How do you repair 1994 Plymouth duster speedometer cable?
A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.
Location of position pedal sensor?
It is located on the side of the engine where the cruise/accelerator cable and A/T kickdown cable all join together.
Where is the iac on Pontiac Sunfire?
Generally, on ther throttle body. It is located 90 degrees from the accelerator cable.
How do you change accelerator cable on 1985 corvette?
The 1985 Chevrolet Corvette accelerator cable is held in place with a swivel nut on each end of the cable. Turn the swivel nuts to the left to remove the cable. Reverse the process to install the new accelerator cable.
How do you install an accelerator cable on a 1983 Chevy Silverado C-10?
Your 1983 Chevy Silverado accelerator cable is held in place with swivel nuts on each end of the cable. Connect the accelerator cable and secure it by turning the swivel nuts to the right.
How do I remove a alternator in a 1995 Plymouth voyager.?
To remove the alternator from a 1995 Plymouth Voyager, first, disconnect the negative battery cable to prevent electrical shocks. Then, remove the serpentine belt by loosening the tensioner pulley. Next, unbolt the alternator from its mounting bracket and disconnect the electrical connectors. Finally, lift the alternator out of the engine compartment.
Opel Signum accelerator cable where is it in the engine?
In the Opel Signum, the accelerator cable is typically located on the throttle body, which is part of the intake manifold assembly. It runs from the accelerator pedal in the cabin, through the firewall, and connects to the throttle body to control the engine's air intake. To access it, you may need to remove any engine covers or components obstructing the view. Always refer to the vehicle's service manual for specific guidance on locating and servicing the accelerator cable.
How do you fit a accelerator cable pin on a 306 hdi peugeot?
To fit the accelerator cable pin on a Peugeot 306 HDi, first, ensure the vehicle is in a safe position and the engine is off. Locate the accelerator cable, then detach it from the throttle body by unscrewing or unclipping it, depending on the mechanism. Position the new pin into the accelerator cable end, ensuring it aligns properly, and then reattach the cable to the throttle body. Finally, test the accelerator pedal for smooth operation before closing the hood.
