its called the MAS mass airflow sensor, and its right after your intake. its a big black peice with a plug on it that is part of your intake
3000gt Mitsubishi 1992 is jumping out of reverse
Where is the transmission control module on a 1997 Mitsubishi galant
If it is a manual transmission, then it is on the front of the transmission. It is one of the two electical connectors on the transmission. The other is the vehicle speed sensor on the backside of the transmission.
On a 1993 Mitsubishi 3000GT, the EGR (Exhaust Gas Recirculation) valve is typically located on the intake manifold, near the back of the engine. It is connected to the exhaust system and the intake, allowing exhaust gases to recirculate into the intake to reduce emissions. To access it, you may need to remove some components or covers surrounding the engine. Always refer to a service manual for specific details and diagrams related to your vehicle model.
1991 to 1993 3000gt do not have a crank sensor. Only a cam sensor. And when does go out the car will not start or have a very irregular idle.
Bad struts can cause vibrations while coasting in first gear on a 1993 Mitsubishi 3000 GT VR4. A bad tire can also cause this.
To locate the fuel relay in a 1993 Mitsubishi 3000GT, first check the owner's manual for the relay diagram and location. Typically, the fuel relay is located in the engine compartment fuse box or near the driver's side under the dashboard. You can also trace the wiring from the fuel pump or use a multimeter to test the relays in the fuse box to identify the fuel relay. If needed, online forums and resources specific to Mitsubishi 3000GT enthusiasts can provide additional guidance.
To disable the low windshield washer fluid indicator light on a 1993 Mitsubishi 3000GT, you can locate the washer fluid level sensor, typically found in the washer fluid reservoir. Disconnect the sensor's electrical connector or remove the sensor entirely; however, this may lead to the light staying on regardless of fluid level. Keep in mind that disabling the indicator is not recommended, as it can prevent you from knowing when to refill the washer fluid.
its in the intake manifold
on the intake manifold on the driverside.
The IAT sensor is installed in the intake air duct
YES.