It is located top left of the motor if you are looking at it from the front bumper
it has 250 horsepower
the starter is on the driver side in the front of the motor near the transmission.
The blower motor on a 1997 Pontiac Bonneville is located next the evaporator core. It will be mounted behind the glovebox on the passenger side of the vehicle. Remove the glovebox, mounting hardware, and sensor clips. The blower motor will be able to be replaced.
Under passenger side by firewall.
the fuel filter is on the passengers side of the car by the right front wheel behind the bottom of the motor
Under the hood to the left of the blower motor mounted in the housing on the firewall...
underneath the dashboard on the passenger side.
On the passenger side of the car behind the glove box. Get to from the inside.
Where is the motor mount located on 1995 grand am
The 2005 Pontiac fan motor resistor is located on the back of the fan motor. The fan motor resistor is attached to the fan motor with two retaining screws.
The starter on a 2001 Pontiac Trans Am is located on the driver's side of the motor. It is down low towards the back of the motor.
passenger side of car under the kick panel under the dash
This is a vertical unit directly behind the water pump on the passenger side of the motor.
did you check ur fusebox to see if the fuse burnt out ?? , or ur sunroof motor is bad
Resistor is located behind the blower motor assembly.
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
don't think motor mounts will work - look for 92-99 3800
i need to know how to remove a blower motor from a 2002 bonneville.
NO, the 1985 Bonneville is rear wheel drive the 1995 is front wheel drive. Even if both engines are the 231 V6 you will have many problems as there were changes such as mounting points, wiring and engine computer cotrol, accessories, ect. Easiest would be to locate a similar year 231 (3800) .
Rear of engine follow exhaust manifold at rear of motor(closest to firewall) you will see oxygen sensor there.Simple to remove(1 only on this motor)
I read that bad motor mounts can cause this knocking sound