behind right rear 1/4 trim panel
Where are the fues located for the control ride on a yukon denali xl
Where the fuse to the ride control for yulon xl
how much it cost to fix service ride control for Yukon XL
why does my service control light come on
To reset service ride control light on yukon detail one must use their manual to determine which button or switch is used to reset the control light properly.
replace fuse or rear shocks
Control Module Control Module is located on the firewall just inboard of the master cylinder. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the instrument cluster panel. 3. Remove the front control module mounting bracket screw. 4. Remove the rear control module mounting bracket screw. 5. Lift the control module and mounting bracket from the instrument panel and detach the control module electrical connectors. 6. The installation is the reverse of the removal.
It is located in the trunk up underneath the rear speakers. There should be a few clips and 2 nuts holding that panel up. It is stored where the factory amps are and if your car HAD a phone where that module is too.
there is humidity in your engine control module
Its on the driver side rear mounted on the frame next to the tire , The air ride exhaust valve is mounted on the air ride compressor unit and its not serviceable .. A new air ride compressor unit must be purchased ... If you have code C0660 make sure you check the valve circuit , with main harness to pump removed , check wires blue and white for resistance with an ohm meter and should measure 18-45 ohms , sometimes they develop an open circuit causing the code to pop up , if valve circuit is within specs check wiring harness and ride control module... Mondo in Texas
Year and model would be really great as you could be talking about a semi truck or a lincoln. But on late model Lincolns the air ride is monitored by the BCM or body control module, any adjustments will need to be made by a computer that can interface with it.
Shouldn't, but if you tow a Denali remember that you can't tow it with any tires on the ground. They must all be either dollied or flat bed only. The transfer case will be damaged and a good chance of the differentials and transmission being damaged also. As far as the service ride control it should have reset once it was no longer being towed unless there is something actually wrong. If its still showing the warning get it looked at. Towing an all wheel drive vehicle can potentially cause issues if it was done improperly. Your manual has information on the correct way.