behind right rear 1/4 trim panel
Where are the fues located for the control ride on a yukon denali xl
Where the fuse to the ride control for yulon xl
how much it cost to fix service ride control for Yukon XL
why does my service control light come on
To reset service ride control light on yukon detail one must use their manual to determine which button or switch is used to reset the control light properly.
replace fuse or rear shocks
The 2002 Yukon Denali is equipped with rear air-adjustable shocks, which help optimize ride quality and load leveling by adjusting the air pressure within the shock absorbers. These shocks automatically adjust to varying loads, providing a smoother ride and improved handling. If you're experiencing issues with the air shocks, such as a sagging rear end or a rough ride, it may indicate a leak or failure in the air system that may require inspection or replacement. Regular maintenance is essential to ensure the air suspension system functions properly.
Control Module Control Module is located on the firewall just inboard of the master cylinder. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the instrument cluster panel. 3. Remove the front control module mounting bracket screw. 4. Remove the rear control module mounting bracket screw. 5. Lift the control module and mounting bracket from the instrument panel and detach the control module electrical connectors. 6. The installation is the reverse of the removal.
It is located in the trunk up underneath the rear speakers. There should be a few clips and 2 nuts holding that panel up. It is stored where the factory amps are and if your car HAD a phone where that module is too.
there is humidity in your engine control module
Its on the driver side rear mounted on the frame next to the tire , The air ride exhaust valve is mounted on the air ride compressor unit and its not serviceable .. A new air ride compressor unit must be purchased ... If you have code C0660 make sure you check the valve circuit , with main harness to pump removed , check wires blue and white for resistance with an ohm meter and should measure 18-45 ohms , sometimes they develop an open circuit causing the code to pop up , if valve circuit is within specs check wiring harness and ride control module... Mondo in Texas
"Service Ride Control" on a 2005 Cadillac Escalade indicates a problem with the vehicle's air suspension system or its associated components. This warning may signal issues with the air compressor, ride height sensors, or the suspension control module. When this message appears, it is advisable to have the system diagnosed by a professional to ensure proper handling and comfort while driving. Ignoring it could lead to further suspension problems or a rough ride.