answersLogoWhite

0

Lift the hood. Look to the left front of the engine. The alternator is right there. You will see the belt run around its pully, wires going to it, and a tensioner bolt.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the water pump located on your 1992 Nissan Stanza?

Attached to engine block right under alternator


What is the ECCL on a 1992 Nissan Stanza?

E.C.C.L. CRUISE CONTROL! In Nissan!


What are the timing marks for a 1992 Nissan Stanza?

the markings on sprocket


Where is the thermostat located on a 1992 Nissan Stanza?

Follow the bottom hose of the radiator to the block. Where the hose enters is the location. Changing this has been answered.


Where is the ecm located on a 1992 Nissan Stanza?

It is located in the center console. behind the cigarette ash tray. It is the one that has a large blue colored connector (many wires are connected to it).


Where is the fuel filter located on a 1992 Nissan Stanza?

the fuel filter is located on firewall on drivers side......has 2 fuel lines going to it one on bottom and one out of the top


What is the Weight of 1992 Nissan stanza?

The weight of a 1992 Nissan Stanza sedan is approximately 2,800-3,000 pounds. This weight can vary based on factors such as engine type, trim level, and optional features.


How many fuel filters are on a 1992 Nissan Stanza?

One in line fuel filter.


How much oil do you need to do an oil change for your 1992 Nissan Stanza?

4 quarts


What size are 1992 Nissan Stanza a front and rear speakers?

6.5. All four of them


How do you replace brake pads on a 1992 Nissan Stanza?

You will need to remove the tire and wheel from your 1992 Nissan Stanza. Remove the brake pad spring and caliper. The brake assembly will come off. Reverse the process to install the new brake pads.


Where is the voltage regulator located on a 1992 Nissan D21 Hardbody?

On a 1992 Nissan D21 Hardbody, the voltage regulator is typically integrated into the alternator assembly. To access it, you'll need to remove the alternator from the engine bay. Once the alternator is out, you can find the voltage regulator attached to it. Make sure to follow proper safety procedures when working with electrical components.