answersLogoWhite
Headlights Tail and Brake Lights
Chevy S-10
Ford F-150
Classic 1964-1978 Ford Mustangs

Where is the backup-neutral switch on a 1998 Chevy S10 4-cylinder?

798081

Top Answer
User Avatar
Wiki User
2006-03-10 10:53:27
2006-03-10 10:53:27

The switch is on the left sie of the transmission just in front of the speed sensor for a manual transmission.

1

Related Questions

User Avatar

can i pull a chevy caviler motor 1998 2.2 4cylinder from the top or do i have to drop it from below

User Avatar

1998 chevy malibu programe new switch

User Avatar

I have a 1998 Chevy 2500. I would like to know how to install the brake switch, and does the switch affect tran from park to drive in shifting?

User Avatar

does the 1998 Chevy lumina have a fuel shut off switch

User Avatar

How do you install a turn signal switch on a 1998 Chevy Tahoe?

User Avatar

The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.

User Avatar

On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.

User Avatar

It is quite simple to change the brake light switch on your 1998 Chevy S 10 pickup truck. The brake light switch simply plugs in and out.

User Avatar

Where is coolant fan switch located on 1998 chevy Malibu with 3 .1

User Avatar

If you are referring to an inertia switch for the fuel pump, no.

User Avatar

The fuel system on a Chevy is controlled by a relay. There is no inertia/reset switch.

User Avatar

where is the fuel pump inertia switch located on a 2000 blazer

User Avatar

If you are talking about an inertia switch, it doesn't have one.

User Avatar

The 1998 Chevrolet blazer fuel pump relay switch can be found on the frame of the vehicle. The switch will be next to the fuel tank.

User Avatar

The 1998 Chevrolet Cavalier brake relay switch can be found below the dashboard, on the drivers side of the passenger compartment. The brake switch simply plugs in and out.

User Avatar

You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.

User Avatar

assuming itis the switch and not the motor remove switch n hot wiretillup or use switch out of other side.....

User Avatar

It doesn't have one, that is a Ford thing.

User Avatar

The low pressure switch is mounted near the ac compressor. It is a two wire switch mounted in the low side line.

User Avatar

GM vehicles do not have a fuel pump inertia switch.

User Avatar

The illumination switch may be in the off position.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.