0
What else can I help you with?
Where is the slave cylinder?
It depends on the slave cylinder that you are asking about. The slave cylinder for a hydralic clutch would be neer the bell housing to disengage the clutch. The slave cylinder for drum brakes would be inside the drum between the two shoes, and pressure applied into this cylinder would engage the brakes.AnswerThe clutch slave is inside the bell housing on most of these. You have to pull the transmission etc to change it out. ANSWERSTRANSMISSION HOUSING OUTSIDE FLUID PIPE
What else is a bell housing called?
Clutch housing, torque converter housing
Where is the bell housing on a Jeep?
The bell housing is the part of the transmission case that bolts to the engine. The bell housing contains the clutch or torque converter.
Where is the clutch slave cylinder located on 1993 jeep cherokee?
Inside the bell housing.Inside the bell housing.
The clutch went out in your 2001 eclipse gt and you can't get the transmission to break free from the bell housing Any suggestions?
why would you want to braek the bell housing free from transmission ? the bell housing needs to be removed to replace clutch, so remove bell housing and transmission as one unit.make sure starter motor is removed. usually blts the secure bell housing and transmission toether can only be reached from inside bell housing after bell housing and transmission are removed from vehicle
How do you replace a clutch on a 2001 Ford Focus SE?
First remove front axels, then remove the transmission, undo clutch bell housing. Add on new clutch pressure plate.....new clutch bell housing......put the transmission back in and axels
Can crankcase oil migrate into the bell housing and contaminate the clutch?
Absolutely!. If the rear seal on the crankshaft is leaking the oil from the engine can migrate to the bell housing and the clutch. It is also possible that the front seal on the transmission can leak and migrate to the clutch.
Where is the bleeder screw located on the clutch system on the bell housing for a 1991 Nissan pickup?
on the slave cylindar rite next to the hole in the bell housing
What is a clutch linkage?
The rods that go from the peddle through the firewall to the bell housing on the transmission to engage /disingage the clutch
What is a clutch slave cylinder?
It is the part of the clutch hydraulic system that pushes on the pressure plate. It is normally located on or in the bell housing.
Why wont your clutch grab on your 2000 tiburon?
It is either worn out , glazed, or there is a fluid leak in the bell-housing , or clutch enclosure.
Where is slave cylinder located on a 2002 Kia Spectra?
The slave cylinder on a 2002 Kia Spectra is located on the transmission, typically near the bell housing. It is connected to the clutch fork and operates to disengage the clutch when the pedal is pressed. Accessing it usually requires removing the transmission or components around it, depending on the vehicle's configuration.
