Rear of the engine - front of the transmission
the starter is located on the bellhousing towards the passenger side
Yes! if its just the transmission, and no bellhousing, its a 25 minute swap, i think there might be about 8 or 9 bolts to remove including the driveshaft.
yes i just went from a small bell housing to a large bell housing in my mustang it works. the flexplate motor plate and converter has to be used with that tranny.
50/91
Yes the front seats from a 89 mustang v6 will fit in a 91 mustang, the tracks are the same.
green.
Yes.
50/91 is already simplified.
91 over 50 as a percent = 182%% rate:= 91/50 * 100%= 1.82 * 100%= 182%
If it's the 5.0 model, it's to the left (looking at the front of the car) of the transmission bellhousing underneath the car.
It is doubtful as the bolt pattern on the bellhousing is most likely different.
In the fuel tank