The "bleeder screws" that come to mind are:
where is the coolant bleeder screw located on a 2002 ford escape
Bleeder screw for clutch is at the slave cylinder, on the bell housing of the Transmission. The bleeder for the brakes is on the calipers, and on the backing plate of the rear drum brakes
The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.
The coolant bleeder valve on a 2000 Ford Windstar is located on the engine, near the thermostat housing. It is typically a small, plastic or metal screw that can be found on the upper part of the engine, often on the intake manifold. To bleed the cooling system, you would loosen this valve to allow trapped air to escape while the engine is running. Always ensure the engine is cool before attempting to locate or operate the bleeder valve to avoid burns or injury.
The 2002 Ford Windstar ECU can be found on the firewall in the engine compartment. The ECU will be on the drivers side of the firewall.
I was looking at the 2002 Ford Windstar Owner Guide and it shows : ( 5W-20 is recommended )
According to the 2002 Ford Windstar Owner Guide : ( 98.4 litres / 26.0 U.S. gallons )
In a 2002 Ford Windstar : ( # 17 ) is a 20 amp fuse for the cigarette lighter / powerpoint and the Datalink connector
That's your LOW tire pressure warning light in a 2002 Ford Windstar
Its on all 4 wheels on the brake caliper.
i put on Scan cyinder 2 misfire on ford windstar 3.8 liter year 2002
On a 2002 Ford Windstar : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver