0
under the hood on the passenger side four screws holding it in. remove coolant reservoir first
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Why does heater blower on 1992 s10 run on high only?
Probably the blower motor resistor is shot.
Where is the heater blower fuse for 94 Dodge Shadow?
fuse location 7
Where is the heater blower relay on a 1995 s10 blzer?
Under the hood, on the firewall, passenger side, nearby the blower motor speed resistor.
Why would a 94 civic heater blower stop working?
Blown fuse? Bad blower motor? Bad blower motor resistor? Bad blower motor switch?
Why will a heater still not work after changing the blower motor and resister and control switch on a 1998 s10?
I hope you checked the fuse.
Can the heater blower motor in a 1999 S10 pickup be repaired and not replaced?
no, the bearing usally go out on them. i just replaced the 1 on mine.
Where is the blower motor resistor on a 1996 Chevy s10?
it should be on the top of the heater core box in the engine compartment, it will have a wires running to it
My Heater in s10 wont blow the heat out through my vents what could be the problem?
somtimes a mouse moves into the blower motor and makes a nest ?
Where is the heater fan resistor located on a 99 chevy S10 blazer?
Under the hood, on the passenger side of firewall, near the blower motor.
What causes the heater blower to work sometimes then to not work other times in a 2002 Chevy s10?
The heater blower switch and the electrical plug attached to it may be at fault. Remove the heater control unit from the dash and inspect the plastic electrical plug attached to the blower switch, you may see it has melted. The switch and plug is available from your local auto parts store.
94 jeep Cherokee heater motor only worked on high and now does not work at all?
Probably the blower motor resistor, check blower motor at the same time
Why wont your Heater Blower switch work in your 94 Sundance?
did your heater switch go out all of a sudden or did some work like high work and low not work? if some worked your blower resister is most likely bad under your glove box
