0
What else can I help you with?
Where is the Blower Motor Resistor Pack located on a 2000 Chevy Impala and how do you change it?
There is a removeable panel below the glovebox. It is in front of the blower motor against the firewall. It has a wire connector from the loom and then it plugs into the blower motor
Your 2000 Chevy Impala the blower motor only works sometimes what could it be.?
Loose connection or blower motor is bad
How do you get to the Heater Blower motor on a 2000 Chevy impala?
down uner the glove box
Where is the blower motor located on the 2000 corvette?
== ==
Where is the blower motor located on a 2000 Chevy Malibu?
The blower motor is under the glove compartment
Where is the blower motor on a 2000 Saturn LS located?
The blower motor is underneath the passenger side dash.
Where is the blower motor relay on a 2000 Chevy Silverado?
the blower motor relay is located next to the blower motor it is connected to the motor by a purple and black wires
Where is the blower motor resistor on a 2000 Ford Ranger XLT 3.0 V-6?
The blower motor resistor assembly is located to the right of the blower motor. The blower motor is located in the engine compartment on the passenger side of the firewall.
Where is the blower motor resistor located on a 2000 Ford E150 van?
It is located on the passenger side of the engine compartment firewall next to the blower motor.
What would make only 5 of the Air Conditioner in a 2000 Impala work?
If you are referring to the blower motor speed, and only the highest setting works, then the problem is a bad Blower Motor Resistor Pack.
Where is the blower motor for a 2000 impala?
It's located underneath the glove box on the passenger side. There's a trim panel that you need to remove to access it. I have included a link to a video that will walk you through the process of removing the panel and also how to replace the old blower motor with a new one.
Where is the blower motor resistor in a 2000 Chevrolet Impala?
Blower Resistor is located near the passenger side floor. There is a black cover over the blower housing. Remove the cover and you should see it. You may need to pull the carpet back to get access to the resistor. Also be sure to have a
