The rake light fuse is in slot 18 and 38 in fuse box under steering column. Access fuse box by loosening 4 plastic screws and removing kick panel. Refer to owners manual for location of additional fuses.
When connecting trailer to vehicle, ensure wire connection is dry. Wet connections may cause short, or malfunction of driver-side high brake light (tail light may still work). Resolve issue by disconnecting trailer wires from vehicle, and dry all connection points. Turn off vehicle, wait 1 hour for system to cycle, turn on and check brake light. If still not resolved, check fuses 18 and 38.
all brake light switches are connected to the brake pedal --- any car or truck or van
The brake light fuse on a 2003 Jeep Grand Cherokee can be found by looking at the cover to the main fuse box. It identifies each fuse and its location.
brake light and battery light is on
Where is the brake light switch for 2003 hd Chevy truck As far as I know, all brake switches are on the top of the brake pedal arm.
possibly have a brake light out
You need brake fluid
It is on a bracket next to the brake pedal.
The brake light switch is above the pedal.
Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.
There is no brake fuse on the 2003 Venture. there is a EBCM/EBTCM. This module controls the ABS in your vehicle.
The parking brake light comes on when you engage the parking brake. Pull the parking brake release handle. ------------------------------------------------------------------------------- the brake light also comes on if the brake fluid level in the brake master cylinder is low ( in your engine compartment )
You have a problem with the brake system. Once you repair the problem the light will reset itself.