Headlights Tail and Brake Lights
Oldsmobile Ciera
Oldsmobile Cutlass
VW Jetta

Where is the brake light switch located on a 1990 Cutlass Ciera?

202122

Top Answer
User Avatar
Wiki User
Answered
2006-04-18 01:55:23
2006-04-18 01:55:23

The brake light switch is located on a bracket behind the brake pedal support.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A 1985 Cutlass Ciera uses type DOT3 brake fluid. It is the standard type of brake fluid for cars with power brakes.

i need picture of 94 cutlass ceira rear brake assembly

Check the brake light switch, it's under the dashboard, connected to the brake pedal.

I work in the auto parts business and it is located under the brake pedal.

The brake light switch must be broken or out of adjustment. The switch is located above the brake pedal. what if it don't cut off

My 1991 Olds Cutlass Ciera had that problem and it was corrected by replacing the turn signal switch. Troubleshooting with the factory service manual pinpointed the problem. Paul S

The best place to find the brake line schematic for a 1995 Cutlass is at a GM dealer. The repair facility would have all of the relevant manuals.

The brake switch is located on the brake master cylinder!

This is an easy one... Is the fluid green? if it is, it's coolant.. if not, its brake fluid.

It's probably your'e brake light switch sticking ,i think it's down under the brake pedal connected to the pedal try pulling up on pedal , check switch,unplug it see if lights go out

The brake light switch will be located somewhere on the brake pedal lever or at the place where the lever connects to the dash brace.

On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.

It is located near the top of the brake pedal.

It will either be a mechanical switch located on the brake pedal lever under the dash, or a pressure switch located on or near the master cylinder.

The B.O.O. switch or Brake On/Off switch is located at the top of the brake pedal assemble.

If it has a mechanical brake light switch it is located somewhere on the brake pedal. Normally around the area where the pedal connects under the dash. If it has a pressure switch, it will be located somewhere on brake lines near the master cylinder.

The tcc switch (tcc brake switch) is located under the dash near the brake pedal. The tcc solenoid is located under the side cover in the transmission/transaxle. The tcc switch (tcc brake switch) is located under the dash near the brake pedal. The tcc solenoid is located under the side cover in the transmission/transaxle. The tcc switch (tcc brake switch) is located under the dash near the brake pedal. The tcc solenoid is located under the side cover in the transmission/transaxle.

There is no brake light switch. There is a brake light pressure censor that is located under the cab where the driver's seat is. T.R.

The brake light switch is located above the brake pedal on a 1993 Nissan Sentra. To reach the switch the driver's door needs to be opened.

A 1990 Cutlass Ciera might hesitate and sputter when the gas pedal is depressed because of water in the fuel or because of damaged or dirty fuel injectors. You might also have an issue with the wiring or the distributor.

the turn signal switch is located inside the steering wheel colum. you have to take it apart using a lockplate remover. the brake light switch is located just above the brake pedal


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.