Where is the brake light switch on a 94 Aerostar?
It is on the brake pedal. There should be two wires connected to it. I found it last weekend after I could not get the van out of park, one of the wires broke off the switch.
Number 1 space, 15 amp fuse. Read More
attached to the brake pedal up under the dash. Read More
WikiAnswers does not have pictures available. Read More
I work in the auto parts business and it is located under the brake pedal. Read More
Check the fuse, check the bulbs, then check the brake light switch. Read More
check the brake light switch behind the brake pedal under the dash. Read More
Usually located at the upper end of the brake pedal under dash area Read More
Check brake fluid level. Check parking brake switch- make sure it is fully depressed and has not become misaligned. Read More
What if your brake lights are stuck on can you unplug 1 side of your battery on a 94 mercury villager?
"Stuck" brake lights indicate that the brake light switch on the brake pedal is broken. It should be replaced. Read More
need a wiring diagram for a 94 chev cab for the brake light switch Read More
Check the bulbs first. I had the same problem on a 94 Oldsmobile and it was the dimmer switch. Replaced that and fixed the problem Check the bulbs first. I had the same problem on a 94 Oldsmobile and it was the dimmer switch. Replaced that and fixed the problem Read More
You have a bad ground on that brake light bulb. Read More
When working on a vehicle it is important to have a diagram. The brake diagram can be found in maintenance books and in online forums. Read More
I have a 94 mustang and the switch is in the trunk, left side by the brake light. You can see it as soon as you open the trunk and look on the left side behind the brake lights. Maybe yours is located there too. Good luck.. Read More
It's located on the top of your brake pedal. Read More
On my 94 ranger its on the break pedal (towards the top) its pretty easy to replace I have changed 3 times in 12 years Read More
Check the fuses then check the brake light switch. Read More
Check the bulbs they are double filamented -smaller for brake lights larger for tailights Check the fuse Check the stop light switch usually located at the upper end of the brake pedal under dash area Read More
There is a short in the wiring or a corroded brake light receptacle. Read More
The signal light switch is part of the multifunction switch on the steering column. Read More
If neither one is working, the first thing to check is your fuse. If the fuse is okay, replace the bulbs and if that doesn't work, it's probably the brake light switch. The switch is the least likely culprit though because they rarely go bad. Read More
You replaced the brake light switch on the pedal of your 94 silverado but the lights still dont work Fuses and bulbs are fine Lights work straight wired?
you need to do a continuity check on the switch. its possible that even the replacement is bad as well. Read More
Why would the brake light on the dashboard be lit on your 94 ford escort lx wagon while the brake is not on?
To indicate a problem with the brake system. Read More
transmission Read More
More than likely, your brake switch is fused, or stuck down.... here. when you push on the brake, the pedal taps a button to indicate that the brakes have been pressed. this button is a gate to the power provided to the tail lights, therefore, when it is pressed, they light up. this button could be stuck. disconnect the harness and see if the lights go off. if they do, replace the switch. Read More
It's probably your'e brake light switch sticking ,i think it's down under the brake pedal connected to the pedal try pulling up on pedal , check switch,unplug it see if lights go out Read More
If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal. Read More
brake switch try some wd40 on it first if no help then replace it. by the way it is up where the brake pedal rests under the dash. Read More
you are going to have to find where power is shorting to ground. start at the brake light switch at the brake pedal. are wires touching metal? any exposed wires? if so insulate them and test. is switch in good shape? if problem continues go to lights themselves and do same. trace wires down and look for breaks and frays. how about 3rd light in rear window? Read More
What exactly do you want to know about "Air conditioning clutch on a 94 ford aerostar van?" How to replace? What engine do you have, etc.? Read More
first see if its low on fluid if not there's a fault in the switch ----In my 94 the Abs Inop Light was on. This Caused my cruise control to stop working. My third brake light was out on my spoiler and simply replacing it caused the light to go off and cruise to start working Read More
Sounds like it's not your bulb that is bad. It may be your brake switch isn't working. Read More
The Turn Signal and Brake Light may be operating from the same Bulb, or separate bulbs. Regardless, the Brake light filament must be burned out. Another option is that the Brake Light Circuit is on a separate Fuse, and the Fuse is blown. Check for those possibilities. Read More
Where is the 2-wire switch on the brake pedal that opens when depressed and lights the tail lights on a 94 Honda Accord LX Is it under the hard-rubber covering Behind the pedal?
Just follow the brake pedal up until you find a switch that has a little piston coming out of it up againts the pedal arm itself. It may be a 5 wire switch not a 2 wire switch but in any case it the brake light wire that turns on the brake lights will be the wire that changes to hot (12 volt pos) when the peddal is pressed. Hope this helps. Read More
You have a 94 Toyota Camry and the reverse lights have stopped working why won't they light up the neutral safety switch and brake switch are good also Where are the fuses for the reverse lights?
Apperently there are no fuses for the reverse light. First check the wiring that goes down the trunk. The wire tend to split due to the trunk going up and down. Read More
check break fluid level Read More
94 AEROSTAR no headlights I replaced the headlight switch no help checked the bulbs checked good checked the fusible link on the stater relay but there was no fuse in the harness now where do i go?
I would go to the high beam switch next (test not replace) Read More
Put a jumper wire across the terminals on the switch if the lights work (with ignition switch set to "on" position) switch is defective Read More
Your problem is not the warning light. The light is on because there is a problem with the Anti-Lock Brake System (ABS). Have it repaired and they will reset the light. Read More
( there are 6 engine cylinders ) for the 1994 Ford Aerostar 3.0 liter V6 engine Read More
Open the trunk and look on the panel beneath the brake light and you will see the socket. Twist and pull it down. Replace the bulb with the exact as you take out. Read More
unplug it unscrew it remove it. bidda bodda boom. Read More
The 1994 Pontiac Bonneville fog light switch can be found on the center console. The fog light switch will be?æbelow the climate control panel. Read More
Switch on brake pedal needs tightened replaced, or switch for lights needs tightened or replaced. Read More
The switch is integral to the transmission. Read More
under the hood in the fuse/ relay/solenoid box Read More
Your problem very well could be the hazard switch. i have a 1994 honda civic too i found whenever i disconnected the hazard switch from the wiring harness my turn signals brake lights and of course hazards do not work. Maybe replace the hazard switch.. Read More
Either the oil is low, as you brake the remaining oil sloshes forward in the sump away from the pickup and the oil pump can only pickup air so the pressure in the oil gallery drops and the oil pressure light to comes on. or The wire to the oil pressure switch is off or bare and as you brake it moves forward and touches some metal causing the light to come on. Read More
Exact same issue. Third light only light that works. If you apply pressure on hazard switch all 3 lights will work. Apparent short in Hazard switch. Bought replacement switch on auction site for $60(includes cruise,turn,wiper&hazard). Will update after install if issue not resolved. Could B the Brake light switch that is activated by the brake prdel ynder the drivers dash & also the brake lights run through the turn-signal switch which runs through the steering… Read More