The camshaft position sensor is integral with the distributor. So, have it checked carefully by a professional because, if the sensor is faulty, the distributor must be replaced. That can get ugly expensive real quick.
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
The camshaft position sensor is an intregal part of the distributor, therefore if the CMP sensor is defective the distributor must be replaced. Have it checked out by a qualified mechanic.
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
are you sure it is not tail shaft sensor. This would be for your speedometer
No
CMP= Cam Shaft Position Sensor.
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
I think you mean CAMSHAFT position sensor.
Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..
A Crank Shaft Position Sensor is a magnetic sensor that determines the position of the engine's crankshaft. It is used to set the electronic timing for the car's computer, so it is a very important part of the electronics.
the crank shaft position sensor should be behind A/C compressor.
I had mine done a couple years ago. If I can remember right, it was about $250.