0
What else can I help you with?
How do you remove front axle shaft on 97 mercury villager?
Yahoo Groups has a very helpful group; villagerquest. It is here you find the answer(s).
1994 Mercury Villager steering pops while turning right?
Sounds like a drive axle half shaft. Have it replaced. Not that expensive.
How do you change a CV boot on a 1999 Mercury Villager?
Changing CV boots is not cost effective. It is much simpler to simply swap in a rebuilt CV shaft.
How do youchange cvboot on 99 mercury villager?
Since rebuilt CV shafts are available for only $60-70, it's more cost-effective to just swap out the shaft.
Where is the cranck shaft sensor located for a 95 mercury villager?
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
Where is the crank shaft sencer located in a 2000 mercury villager?
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
Why is distributor in Mercury Villager not turning?
A couple thing come to mind. Broken timing belt, broken camshaft, broken distributor shaft. Are you seeing the trend here?? I think your engine is BROKEN.
How do you replace the shift shaft on 1973 50hp mercury?
To replace the shift shaft on a 1973 50hp Mercury outboard, first, ensure the engine is securely tilted and disconnect the battery. Remove the lower unit by taking out the bolts and carefully separating it from the powerhead. Once the lower unit is off, you can access the shift shaft; remove the retaining pin or screw, then pull the old shift shaft out and replace it with the new one. Reassemble the lower unit, ensuring all connections are secure, and test the shift mechanism before reattaching the battery.
Mercury villager rear wiper motor runs all the time?
You may want to try removing the wiper blade and shaft nut first to eliminate the blade from continually moving. Then, consult your mechanic.
Where is the speedometer cable on a 2000 mercury villager located?
The speedometer cable on a 2000 Mercury Villager is typically located on the transmission. It connects to the vehicle's speed sensor, which is situated near the output shaft of the transmission. To access it, you may need to raise the vehicle and remove any protective covers or components obstructing the cable's path. Always consult the vehicle's service manual for specific instructions and diagrams.
Where is the cam shaft position sensor in a 1999 Mercury Villager?
The camshaft position sensor is integral with the distributor. So, have it checked carefully by a professional because, if the sensor is faulty, the distributor must be replaced. That can get ugly expensive real quick.
How do you replace axle shaft on 1997 mercury villager?
Because of the complexity of this kind of job, it is strongly suggested that you buy a repair manual that explains it in detail. You need to loosen the axle nut with the car on the ground, raise the car, remove the wheel, unbolt the lower ball joint, tie rod end stud, strut lower through bolts, remove the brake caliper, then you can tap the CV shaft stud back and pull the spindle assembly free of the CV shaft. The driver side CV shaft can then be popped out of the transmission. The passenger side CV shaft has a carrier bearing with three bolts holding the shaft to the bearing. Do not try to take the bracket off the engine, it is not necessary. Installation is the reverse of removal.
