Car Computers and Sensors
Ford Taurus
Crankshaft Sensors

Where is the cam shaft position sensor on a 1996 Ford Taurus?

495051

Top Answer
User Avatar
Wiki User
2006-04-26 12:17:50
2006-04-26 12:17:50

if its a 4v it under the valve cover. if its a 2v it is on top of the half distributor at the rear of the engine under the throttle body.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..

User Avatar

the last time i checked it was what connected the pistons together and made it run

User Avatar

On the harmonic balancer that's attached to the front of the cranck shaft

User Avatar

The 1996 Ford Taurus heated oxygen sensor can be found behind the dashboard on the passenger side of the passenger compartment. The oxygen sensor should be labeled as such.

User Avatar

ck cam shaft sensor, check crank shaft sensor also.

User Avatar

The throttle position sensor can be found on the throttle body, opposite end of the throttle cable end of throttle plate shaft.

User Avatar

where is the camshaft position sensor laocated at on a 1996 ls 400 lexus

User Avatar

were is the camshaft position sensor (cmp) location on a 1996 caprice classic

User Avatar

The 1996 BMW 328 camshaft position sensor is located on the front of the cylinder head. The camshaft position sensor should be labeled as such.

User Avatar

Need to know what size engine it has.

User Avatar

This engine has no turbine or turbo. Although the 1996 Ford Ranger does not have a turbine or turbo, it does have a turbine shaft speed (TSS) sensor. It is located inside the automatic transmission.

User Avatar

TPS IS THROTTLE POSITION SENSOR

User Avatar

The camshaft position sensor is inside the distributor.

User Avatar

To test a crankshaft position sensor on a 1996 Jimmy Blazer, use a CKP sensor to test for voltage output. Compare the results to manufacturer specifications.

User Avatar

There is no such thing as an "odometer sensor." There is a vehicle speed sensor that is located on the output shaft housing of the transmission. That sends info to the speedometer. From there, the speedometer and the odometer are both operated internally, so if your speedo is working, but the odometer isn't, you have a problem inside the speedo head assembly.

User Avatar

The Camshaft Position Sensor is located behind the Power Steering Pump.

User Avatar

under the passenger side of the vehicle and look up. You will see The output shaft speed sensor codes maybe similar to P0720>

User Avatar

The crankshaft position sensor is required and can not be bypassed.

User Avatar

The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.