The crank shaft position sensor is located behind the harmonic balancer/crank shaft pully on the front of the engine. You can see the wires for the sensor run behinf the pully into a plastic housing.
Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..
where is the crank position sensor located on 2003 kia Rio 1.8
The crank shaft positioning sensor is behind the starter. A real bear to get to.
Location of crank shaft position sensor of a Nissan altima 2.5 2004? send diagram please
A Crank Shaft Position Sensor is a magnetic sensor that determines the position of the engine's crankshaft. It is used to set the electronic timing for the car's computer, so it is a very important part of the electronics.
Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.
I think you mean CAMSHAFT position sensor.
Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?
crank or cam shaft position sensor is sometime the issue.it will not fuel if it cannot find the position of the cam or crank
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.
location of a crank shaft sensor on a nissan frontier 2002
It is behind the starter.
in the distributor
The camshaft position sensor is located just above the oil filter on the right side (sitting in the vehicle) of the engine.
On crankshaft position sensor, one camshaft position sensor.
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
the crank shaft position sensor should be behind A/C compressor.
Locate crank shaft sensor 2005 Chevy aveo
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
Where is the crank shaft sensor located on a 1992 Pontiac grand am 3.3 motor
Where is the crank shaft sensor located in a Audi a6
Rear of engine between engine and trans but bolted to engineon the top side nest to firewall