answersLogoWhite

0

it on the drivers side on the side of the head just below the valve cover it on the drivers side on the side of the head just below the valve cover

User Avatar

Kenny Donnelly

Lvl 10
3y ago

What else can I help you with?

Related Questions

What does a cam sensor do on a Chrysler PT Cruiser?

It tells the computer the rotational location of the cam shaft. This info is used for fuel and ignition timing.


Where is the cam shaft sensor on a 2002 Chrysler PT Cruiser?

Drivers side of motor, just below valve cover.


Where is cam shaft sensor located on a Chrysler pt cruiser 2.4 touring 2005?

It is on the driv side end of the cylinder head.


Where is the cam shaft sensor on a 2003 pt cruiser?

it on the drivers side on the side of the head just below the valve cover it on the drivers side on the side of the head just below the valve cover


How much does it cost to get a cam sensor replaced on a 2005 pt cruiser?

It cost me $155, parts and labor.


Where is 06 PT Cruiser crankshaft sensor located?

the crank shaft sensor on 06 pt cruiser is located underneath the starter. It's a very tight spot, to remove you need a 8mm socket and you have to unplug the sensor once is out...Don't foget to disconet the battery.


What direction do 2002 pt cruiser cam shaft bolts turn?

Counter clockwise to loosen.Counter clockwise to loosen.


Will a 2005 PT Cruiser engine work in a 2001 PT Cruiser 2.4?

No, the crank sensor tone ring is different. It will not start.


Why is oil leaking at crank shaft on my 2007 pt cruiser?

Failed seal.


Is there a security to reset on a 2001 Chrysler PT Cruiser after the cam sensor and the crank sensor have been changed?

Chrysler does not use reset switches.Chrysler does not use reset switches.


How do you remove the governor sensor in a pt cruiser?

No such part to remove on a PT.No such part to remove on a PT.


How do you replace the crankshaft position sensor on a Chrysler PT Cruiser?

The crankshaft position sensor on the PT Cruiser is on the side of the engine above the oil filter. The sensor is removed with two screws. Unplug the wiring, remove the bolts, then install the new sensor.