For the 2.7l v6 engine, it is located on the left engine bank at the very front of the head. Look down at the front of the engine head, right under the top radiator hose and you will see a connector that is attached to the camshaft position sensor. It is held in place with a 13mm bolt. The top of the bolt has a wire loom cap on it that supports the wiring harness. Remove the plastic cap from the screw top and then remove the bolt with the 13mm wrench. After the bolt is removed, pull the sensor out. It is easier to remove the bolt by first removing the connector from the sensor.
The camshaft is in the cylinder head.
it is an part of the distributor unit. you have to change out the entire distributor.
It is bolted to the driver side end of the cylinder head.
It is on the driver side end of the head.
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
A 2005 Chrysler Sebring does not have a distributor.
There is no such part on a Chrysler Sebring.
Well i'm not sure which engine you have, but i have an 04 Sebring Sedan, 2.4L DOHC (4cyl). and mine was located on the top of the engine right hand side of the head. It took me all of 5 minutes to take off and put the new one on. Good luck Nikki
A Chrysler Sebring does not have a reset switch.
A Chrysler Sebring does not have a reset switch.
Front left cyl.head in the timing belt cover
It is on the top rear of the transmission bell housing.