Take the distributor cap and rotor off and that electric device that you see is the cam sensor.
The camshaft position sensor, which is located inside the distributor, is a pretty easy component to test on the 1992-1995 5.2L/5.9L Dodge Ram 1500/2500 pickup.
It is the "pick-up" plate in the distributor.
The camshaft position sensor is a part of the distributer. There are 2 electrical plugs going to it, 1 is for the coil,the other is for the Camshaft sensor.
It is inside the distributor.
The cam sensor is inside the distributor on a Dodge 5.2L.
Camshaft position sensor circuit malfunction.
To change the camshaft position sensor on a 1995 Dodge Ram 1500, first disconnect the negative battery cable to ensure safety. Locate the camshaft position sensor, which is typically found near the engine block, and unplug the electrical connector. Remove the retaining bolt and carefully pull the old sensor out. Install the new sensor by reversing these steps, ensuring the connector is securely attached and the battery is reconnected.
it is in the distributor
Timing is set by the PCM, there is no adjustment.
The 2000 Chevrolet Silverado 1500 4 x 4 camshaft sensor can be found on the back of the engine head. The camshaft sensor will be labeled as such.
The cam sensor is under the front of the passenger side cylinder head.
It is inside the distributor. It is called a pick up plate.