The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.
The 1999 Ford Ranger 3.0 liter engine throttle positioning sensor is located on the cylinder head. The sensor will be near the middle of the cylinder head.
There is no "camshaft position sensor" in the 1999 ranger 2.5l motor so they have to have a crank position sensor. what kind of problems are you having? i might be able to help. you can email me at firstname.lastname@example.org. I have a 99 2.5 with a P340 code "camshaft positioning sensor circuit malfunction" Supposidly, it is behind the aux pulley.
Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.
unplug wire remove 2 7/32 bolts remove sensor
near the #4 spark plug. 2.0L Engine
The camshaft position sensor is on top of the engine. It is on top of a shaft in the same place that older rangers had a distributor.
its on the top of the cylinder block behind the intake manifold
get a new cam position sensor (about $35)
There isn't one. It only has a dual vane crankshaft position sensor.
cam positioning sensor is on the front of the block, directly above the bottom pulley wheel this is accessed the easiest from underneath the car
top rear of engine
I have the same engine in my 1995 Ford EXPLORER : I can't see the camshaft position sensor but from what I have read it is on the top of the engine , near the center line , at the back of the engine near the firewall
Where is the camshaft position sensor on a 2005 Expedition?
wher is the camshaft sensor for escort2002
p1039 for a 1999 ford ranger indicates a camshaft position sensor fault. it could be the sensor, wiring, or the PCM. must be properly diagnosed to determine the real fault.
The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.
Where is the ford ranger 2004 revcounter sensor conected
On a single cam ford focus 2000-2001 the cam position sensor is below the pcv valve. If looking at the engine it is on the right side, rear, about a 3inches from the top of the engine.
Here is a link... With pictures of throttle positioning sensor... http://www.thepartsbin.com/repsite/ford~throttle_position_sensor~reparts.html
its located behind the intake manifold on the top surface of the cylinder block
A diagnostic tester can tell you if the camshaft sensor is not working properly. Most Ford dealerships have diagnostic testers.
its mounted on the oil pump assembly behind the inner timing belt cover. that's on a 2.3L engine
P0340 is error code for Camshaft Postion Sensor Circuit Malfunction
I'm not a mechanic / technician but from what I have read : The camshaft position sensor on top of the camshaft position synchronizer on the Ford 4.0 liter EFI , V6 engine , is on top of the engine , near the center line , at the back of the engine near the firewall * apparently you can't see it until the upper intake manifold is removed